<div dir="ltr"><div>We have a EV620 Aligner at MTU and this tuesday it did not complete the initialization process after logging in, all reboots and attempts have failed. We have software version 2.64 and we are still running a Win98 system. I am talking to EVG about this problem to get a solution, but being an older system and software version they are still working on it. Therefore I was hoping this community might have faced this issue and have some advice.</div><div><br></div><div>After typing in the password and hitting run the system starts initialization. It moves the optical head, mask stage, WEC, and then gives a double beep - all of this is normal. Instead of bringing up the recipes it has ERROR and look at the log. The log has as the last entry - "Check distance measurement !". All menus are greyed out so I can not access any other part of the software.</div><div><br></div><div>Regards,</div><div><br></div><div>Chito Kendrick<br></div><div><br></div><div><br></div><div><br>-- <br><div dir="ltr" class="gmail_signature" data-smartmail="gmail_signature"><div dir="ltr"><div><div dir="ltr"><span><font color="#888888"><a href="https://sites.google.com/site/chitokendrickphd/" target="_blank">Chito
        Kendrick Ph.D.</a><br>
      <br>Managing Director of the Microfabrication Facility<br>
      Research Assistant Professor<br>
      Electrical and Computer Engineering<br>
      Michigan Technological University<br>
      Room 436 M&M Building<br>
      1400 Townsend Dr.<br>
      Houghton, Michigan 49931-1295<br>
      <br>
      <a href="tel:814-308-4255" value="+18143084255" target="_blank">814-308-4255</a></font></span></div></div></div></div></div></div>