U can simply use a STD small metal wafer holder that have flat area below and u squeeze down to hold pieces or wafers. The trick is getting the pcs off the hot plate. Again, simply using anything metal to push against one side of the wafer or small piece to get it on edge , while u slip the wafer holder underneath sample on the opposite side. Works for us at Aggiefab. We do this every day on PECVD where Temp 350C.<div><br></div><div>Ted Wangensteen, Research Engineer, Texas A and M<br><br>On Monday, December 6, 2021, Bill Kiether <<a href="mailto:wjkiethe@ncsu.edu">wjkiethe@ncsu.edu</a>> wrote:<br><blockquote class="gmail_quote" style="margin:0 0 0 .8ex;border-left:1px #ccc solid;padding-left:1ex"><div dir="ltr">Hello, <div><br></div><div>I'm asking for advice on the best tool set for safely removing wafers (2"-6") or pieces (~ 1x1 cm) from the surface of a very hot (250 C- 350 C) surface,  eg. a hot plate or CVD platen (say 10" diameter).   I have found a vacuum wand tip (Pella) that can handle wafers at 250 C, but the tube is too short (2").  Basically, I'm looking for vacuum wand tips for high temp with at least an 8" tube length, or long pairs of tweezers easily manipulated, or a set of thermal gloves that are dextrous enough to handle tweezers. </div><div><br></div><div>Bill Kiether</div></div>
</blockquote></div>