[labnetwork] Suss MA6 Question

[Aebersold, Julia]

I would ask Mark Anderson of Aligntech.

Mark Anderson
AlignTech, LLC
802-878-0199
markanderson150 at gmail.com<mailto:markanderson150 at gmail.com>

Cheers!

Julia Aebersold, Ph.D.
Manager, Micro/Nano Technology Center
University of Louisville
Shumaker Research Building, Room 233
2210 South Brook Street
Louisville, KY  40292
(502) 852-1572

http://louisville.edu/micronano/

From: labnetwork <labnetwork-bounces at mtl.mit.edu> On Behalf Of James Mitchell
Sent: Wednesday, March 22, 2023 2:30 PM
To: Fab Network <labnetwork at mtl.mit.edu>
Subject: [labnetwork] Suss MA6 Question

CAUTION: This email originated from outside of our organization. Do not click links, open attachments, or respond unless you recognize the sender's email address and know the contents are safe.
Lamp power supply will not turn on after lamp failure.
We had a lamp (350 W) pop on our system.
Cleaned up and installed a new lamp.
When we start the power supply the breaker in the back of the system trips.
Specifically, it trips when we press CP. System starts at STAND-BY.
Press "ON" and the display shows "READY". Press CP and it displays "Wait..." for a second and then trips.
We checked for shorts and all looked good. We swapped to the other 220 Volt plug in the back and it trips as well.
Any ideas on this? We are not sure if the start box or the supply itself is the issue.


Thank you, Jim

James Mitchell
Specialty Trades Technician
Dept. of Electrical and Computer Engineering
North Carolina State University Nanofabrication Facility (NNF)
MRC RM243A Box 7911
2410 Campus Shore Dr., Raleigh, NC 27606
jtmitch5 at ncsu.edu<mailto:jtmitch5 at ncsu.edu>
Desk: 919-515-5394
Cell: 919-717-7325


-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://mtl.mit.edu/pipermail/labnetwork/attachments/20230322/48c8a590/attachment.html>