[labnetwork] DISCO wafersaw software freeze PROBLEM

[Youry Borisenkov]

Hi,
We had similar symptoms on our Disco (in Tel Aviv University). Eventually
the hard drive was replaced by the vendor. This solved the problem.
The vendor also helped to backup tool’s settings, and then rewind to the
new hard drive.

Regards,
Youry

On Sat, Feb 22, 2020 at 8:45 AM Xiaoqing Xu <steelxu at stanford.edu> wrote:

> Hi All,
>
> We have constantly seen our DISCO wafersaw software freeze (it started by
> reading some init files then stopped responding) at the boot up step when
> turning on the tool using the "start" key. We were able to eventually turn
> on the software by trying reboot multiple times, but it got harder and
> harder. Initially we suspected maybe the tool run out of storage (ONLY
> 2GB), but we downloaded all the files and they only counted for over 100KB,
> which indicating not a storage issue. Did anyone see a similar problem, and
> how did you solve it?
>
> Any input is much appreciated!
> Thanks,
> Xiaoqing
>
>
> _______________________________________________
> labnetwork mailing list
> labnetwork at mtl.mit.edu
> https://mtl.mit.edu/mailman/listinfo.cgi/labnetwork
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://mtl.mit.edu/pipermail/labnetwork/attachments/20200222/e3d1e8da/attachment.html>